Our Approach
We measure your system first.
Then we fix what the numbers show.
Every decision we make about your system comes from a reading we took on it. Static pressure, airflow, refrigerant state, and combustion where there's gas.
Our process
Measure first. Then fix.
Observe
We start with the house, not just the equipment. The rooms, the ducts, the envelope, and what you have been living with.
Measure
You get the numbers: static pressure, airflow, temperature split, refrigerant state, combustion. The instruments tell the story first.
Prescribe
We compare the numbers against design and code, name the root cause, and put the fix in writing, in priority order, with the measurements behind it.
Fix
We make the repair you approve, then measure again to confirm it worked. The numbers say when it’s done.
When the fix is a new system
What step four looks like for an installation.
Most fixes are a repair. When the right fix is new equipment or a duct redesign, step four runs longer, and it follows the same rule: nothing is done until the numbers say so.
Design
Solutions are sized to your home and load, not a rule of thumb. Manual J, Manual D, Manual S where applicable.
Implement
Install built to specification, tested on the bench before it’s tested in your house. Clean job site every day.
Verify
We measure again and document the result. You get a commissioning report. The numbers say when it’s done.